PEM® brand fasteners utilize self-clinching, broaching, flaring, surface mount, or weld technology to provide strong, reusable, and permanent threads and mounting points in thin sheet metal, P.C. board materials, and other ductile or non-ductile thin material.
KEY ADVANTAGES OF SELF-CLINCHING FASTENERS
Broadly defined, a self-clinching fastener (also known as clinch or captive fastener) is any device, usually threaded, that, when pressed into ductile metal, displaces the host material around the mounting hole, causing it to cold flow into a specially designed annular recess in the shank or pilot of the fastener. A serrated clinching ring, knurl, ribs or hex head prevents the fastener from rotating in the host material once it has been properly inserted. Thus, self-clinching fasteners become a permanent part of the panel, chassis, bracket, or other item into which they are installed.
Generally, self-clinching fasteners take less space and require fewer assembly operations than caged or anchor nuts. They also have greater reusability and more holding power than sheet metal screws. They are used chiefly where good pullout and torque loads are required in sheet metal that is too thin to provide secure fastening by any other method. Even if the sheet is thick enough to sustain tapping, it may actually be more economical to use self-clinching fasteners with gaugeable threads. They can be installed during fabrication or during final assembly to eliminate loose hardware. In fact, the use of self-clinching fasteners often will support a thinner sheet metal, and permit a real reduction in installed cost over the cost of other fastener designs. Because of their compact design and low profile, they provide for a neat appearance, too.
As a rule, a self-clinching fastener should be specified whenever a component must be readily replaced and where “loose” nuts and hardware wouldn’t be accessible. If the attaching “nuts” and “screws” can’t be reached after a chassis or cabinet is assembled, self-clinching fasteners can be installed during metal fabrication and can simplify and expedite component mounting and assembly operations, including those performed in the field.